Nobody has more router bits &
shaper cutters. Nobody.
CutterBits.Com, formally The Cutting Edge, is a leading centre for router bits and
shaper cutters. We stock a huge inventory.. more than 600 different varieties.
As far as selection, quality and price, the competition doesn't even come close.
For example, we offer you one of the best, if not THE best selection of crown
mouldings, cabinet door sets and panel raisers. Over and over, our customers tell us we're
THE trusted source. You could say, CutterBits.Com is a Cutter Above!
Now, let's tell you about our bits and cutters.
MANUFACTURING:
Our router bits and shaper cutters are made with only top quality C-2, which has been
proven to be the best grade for cutting wood. Our shaper cutters are shaped and sharpened
with diamond wheels as fine as 600 grit, and are suitable for almost every job. But, it is
up to you to match the right cutter to the right job!
CARE:
Always be very careful when handling your router bits and shaper cutters. Carbide is
extremely brittle and can be chipped easily especially if dropped. Do not set router bits
and shaper cutters on hard surfaces. Protect them with a floor mat and bench pad. Neoprene
anti-vibration pads are very helpful. Premature bit failure can be caused by a worn out
collet. Less expensive collets found in less expensive router bits can cause bent shanks
and big trouble. Always watch for wear and tear of the collet to prevent bit failure.
You know this is happening when:
- Collet starts to appear egg shaped
- Bits start to slip or spin-out when cutting
- Twists
- Nicks or burrs on the bit shank
- Vibration and chatter marks.
Remember to keep your router bits in good condition.
USAGE:
To increase the longevity of your router bits and shaper cutters, always:
- Use quality, clean materials
- Avoid heat build-up caused by an improper feed rate. Feeding too slowly can result in
burned out or worn out router bits.
- Keep work secured properly to avoid movement.
- Cut at an even and steady rate.
|
